|
Introduction
Geomet applies tolerance to Sphere features which is limited to Bilateral / Linear in
either Cartesian or Polar formats. To understand the basics of tolerance, please refer to
Introduction to Tolerance in Geomet.
Sphere Features
Tolerance of Spheres is possible in either
Cartesian or Polar formats.
 |
 |
| figure 1, Cartesian Tolerance |
figure 2 - GDT Tolerance |
 |
|
figure 3 - Polar Tolerance |
To activate the tolerance tool see
Working with Geomet Tolerance
Windows
Figures 1 and 2 show Bilateral Tolerance on Cartesian and Polar formats respectively.
To better understand how these formats are
used
and
interpreted, refer
to Introduction to Tolerance.
Related Procedures:
Tolerance State On / Off,
Tolerance Format,
Process Control Tolerance,
Out-of-Tolerance Flash
Message
|
